REACTIVO 2 Art-Net Pixel Controller – Standalone Playback

REACTIVO 2 is a compact Art-Net pixel controller. It drives up to 1024 addressable RGB pixels over Ethernet or Wi-Fi. Moreover, it keeps the show running from its own SD card when no console is connected. Two trigger inputs also let a button, potentiometer or sensor take over. As a result, events, theatre, retail displays and architectural installations run unattended.

Description

REACTIVO 2 is an Art-Net pixel controller for addressable LED installations. Every project faces the same question: what happens when the laptop goes home? This unit answers it.

The controller drives up to 1024 RGB or 768 RGBW addressable pixels. It works with any console or software that speaks Art-Net. For example, Madrix, ChamSys, grandMA, Resolume and LED Strip Studio software all control it. Moreover, it keeps playing animations from its own micro SD card when the network goes quiet.

Art-Net pixel controller on any network

Control arrives over wired Ethernet or 2.4 GHz Wi-Fi. As soon as you plug in a cable, the controller switches to it automatically. In addition, a web interface, a mobile app and HTTP commands cover everyday control. Several units can also run in synchronized zones under one master.

Triggers turn it into a standalone show

Two analog trigger inputs make REACTIVO 2 a complete standalone system. Wire up a push button, switch, potentiometer or sensor. Then assign it an action: next animation, brightness, speed or blackout. Because thresholds, hysteresis and press counting are adjustable, the response stays predictable.

Key features:

Art-Net pixel mode and SD card mode with brightness, animation, speed and recolour channels
Master/slave zone synchronization for multiple controllers on one network
Support for WS2811, WS2812B, SK6812, APA102 and more — see the supported IC list
5–24 V DC input with 7 A pass-through, so one supply feeds strip and controller
Channel layout follows the Art-Net 4 specification

Where the Art-Net pixel controller fits

The enclosure measures 85 x 40 x 25 mm and weighs 47 g. Therefore it hides inside a truss clamp, a display plinth or a ceiling void. Signal cable runs of 5–10 m work in most installations. Keep that cable away from power lines to avoid noise. For longer runs, add THE SYMMETRIZER or a TTL Signal Buffer. Finally, Showtacle backs every unit with a 2-year limited warranty. Use it indoors: events, clubs, theatre, scenography, showcases and architectural lighting.

Weight:200 g
Dimensions:85 × 40 × 25 mm
SPI LED Outputs:1
Maximum of LEDs per Output:1024
Required power:1W
MAX. Total Pass Thru Current:7A
Power connector:DC jack 5.5mm/2.1mm
SPI OUT connector:pluggable terminal block with 3.5mm contact spacing e.g. 15EDGRC-3.5-04P
Trigger inputs:2x analog trigger input 0-3.3V with internal 12k pull-ups
Trigger inputs connector:4pin pitch 1.5mm JST ZH compatible
Wired Ethernet:RJ-45 connector, 10/100 Mbps, Auto-MDIX
Wireless Ethernet:2.4Ghz Wi-Fi 802.11 b/g/n
SD Card.Micro SD Card (FAT32, up to 32GB)
ads_priority:yes
Package:OEM, Full-kit
Software license:Art-Net only, LED Strip Studio Edition
OEM | Full-kit
Art-net Only | LED Strip Studio Software
Free consultation

Need help with your installation?

Tell us about your project and our technicians will help you choose the right controller, software and infrastructure.

Looking for a complete setup by application? Explore setups